• Networking

  • How to use SNR tweaking for a faster or more stable connection

It is just a hack for decreasing SNR margin, it will make connection faster, but much more unstable.
Thanks for this, I'll use it to increase my SNR, I prefer having 9mbps stable without packet loss compared to 10mbps non 100% stable
9 days later
I am wondering if I use modified CAT6 between the wall socket and modem if it would improve my stats.

Also, I am using a socket to connect the RJ11 cable similar to an electricity plug (https://3.imimg.com/data3/KE/NM/MY-7939008/two-pin-top-plug-250x250.jpg) where I plug the RJ in its back and it plugs to the wall like electricity plug. Might this cause degradation of signal?
I will have to redo the wall socket to fix that in case it is.
8 days later
https://m.imgur.com/TbGYVtZ

I just tried using Kareem's command on my X1000 and to my surprise it worked!
My max rate jumped from 13 mbps to 18.7, I lowered my SNR from 15 to 9 so I'll be monitoring my connection in the next few days, is 9db considered very low? will it affect gaming etc?
Are you with Ogero?
Because on IDM, whatever is the SNR margin, the rate is locked.. I lowered mine from 14 to 9 and the rate didn't change at all
Sodetel, but now that you've mentioned it on speedtest.net I'm always getting lower speeds, for example I used to get 11mbps now 14 mbps, I'm planning on moving to ogero next month anyways
omar_killer wrotehttps://m.imgur.com/TbGYVtZ

I just tried using Kareem's command on my X1000 and to my surprise it worked!
My max rate jumped from 13 mbps to 18.7, I lowered my SNR from 15 to 9 so I'll be monitoring my connection in the next few days, is 9db considered very low? will it affect gaming etc?
Seems like the target SNR set by Sodetel is 15dB which is astronomically high, as in too safe.
I'm also with Sodetel and I once requested the SNR to be lower than 15dB they kept saying that it's not them who set it. I can't be a hundred percent sure it's them but seeing your feedback that should be it.

Of course after I discovered I could tweak the SNR by myself, I couldn't care less.

Fresh results:

Pre-tweak - 3.2Mbps sync

87.5% throughput

Post-tweak - 7.2Mbps sync

81.9% throughput

204% higher throughput
225% higher sync rate
0% errors
Anyone got a guide on how to tweak TP-link modems (VR-400)
nefe_lpmk wroteAnyone got a guide on how to tweak TP-link modems (VR-400)
I have the tp-link vr900 and I don't think SNR tweaking can be done on these models :(
If someone knows a way however, it would be highly appreciated.
Can anyone give a step-by-step guide as to how to tweak the SNR for the standard Technicolor DSL modems that ogero gives u?
SNR tweaking does not work with IDM /GDS. The SNR changes but the speed is locked at whatever they chose.
No way to tweak the thomson TG585 V8 although it's very easy on the V7, the V8 adslctl command was removed .
6 days later
Kareem wroteFor D-link modems ...

https://i.gyazo.com/2861cf1a5e5782159e75c72753e15955.png

adsl configure --snr xx

To understand more the value of XX, check the link below :

http://www.increasebroadbandspeed.co.uk/SNR-tweak


basically you wanna reduce the SNR Margin ( not SNR ) in steps of 3dB. reduce and test stability. mine won't go below6 dB

I tried Kareem's Tutorial but with no luck, The error is that Invalid parameter.

My guess is that I haven't entered through configuration terminal since the command

>adsl snr
shows
------the table SNR per tones(carriers) of the interface ADSL2+-----

Downstream Upstream
168 266

any tutorial for dummies?
313 wrote
Kareem wroteFor D-link modems ...

https://i.gyazo.com/2861cf1a5e5782159e75c72753e15955.png

adsl configure --snr xx

To understand more the value of XX, check the link below :

http://www.increasebroadbandspeed.co.uk/SNR-tweak


basically you wanna reduce the SNR Margin ( not SNR ) in steps of 3dB. reduce and test stability. mine won't go below6 dB

I tried Kareem's Tutorial but with no luck, The error is that Invalid parameter.

My guess is that I haven't entered through configuration terminal since the command

>adsl snr
shows
------the table SNR per tones(carriers) of the interface ADSL2+-----

Downstream Upstream
168 266

any tutorial for dummies?
What's your router model ?
Adnan wrote
313 wrote
Kareem wroteFor D-link modems ...

https://i.gyazo.com/2861cf1a5e5782159e75c72753e15955.png

adsl configure --snr xx

To understand more the value of XX, check the link below :

http://www.increasebroadbandspeed.co.uk/SNR-tweak


basically you wanna reduce the SNR Margin ( not SNR ) in steps of 3dB. reduce and test stability. mine won't go below6 dB

I tried Kareem's Tutorial but with no luck, The error is that Invalid parameter.

My guess is that I haven't entered through configuration terminal since the command

>adsl snr
shows
------the table SNR per tones(carriers) of the interface ADSL2+-----

Downstream Upstream
168 266

any tutorial for dummies?
What's your router model ?


DLINK DSL-2750U

Click here to see the photo
The C1 revision of your modem has a Broadcom chipset, however the U1 has a Realtek one. Now if you have a Broadcom chipset and it didn't work, it might be that the manufacturer removed the feature.
Kareem wroteNo way to tweak the thomson TG585 V8 although it's very easy on the V7, the V8 adslctl command was removed .
How can we do it on the v7? I've been trying a lot, and it can't seem to work.
mohammadk97 wrote
Kareem wroteNo way to tweak the thomson TG585 V8 although it's very easy on the V7, the V8 adslctl command was removed .
How can we do it on the v7? I've been trying a lot, and it can't seem to work.
There is a custom Firmware for the V7. Check online but I am not responsible for any damage.

Meanwhile :

I noticed today that my DSLAM's target SNR margin was set to 8dB (I am on Sodetel DSP, but I'm not sure who controls this). It was set to 10dB until yesterday. It seems that they're able to put more load on the network so they decreased the SNRM for extra speed.